Shopping Cart

3M™ Scotch-Weld™ Structural Plastic Adhesive DP8010 (Off-White), 35 mL

3M™ Scotch-Weld™ Structural Plastic Adhesive DP8010 (Off-White), 35 mL
UPC#: 0-21200-49110-83M ID: 62278304308

Important Notice

Please note that this item is for industrial / professional use ONLY. Consumer, household or retail use is not permitted.

Product Details


  • Structural strength
  • Glass beads for bond line control
  • Markets: General industrial, metal working, maintenence, repair, construction equipment, agricultural equipment, plastic and rubber industry, medical, sporting goods, solar energy, wind energy, composites, electronics, military, transportation and aerospa
  • Applications: Bonding, gluing, joining, attaching, assembling, encapsulating, potting and sealing


3M™ Scotch-Weld™ Structural Plastic Adhesive DP8010 is a two-part acrylic-based adhesive. 10:1 mix ratio, 10 minute work life and handling strength in approximately 2 hours. 3M™ Scotch-Weld™ EPX™ Plus II applicator and mix nozzles are required (not included).

Bonds many low surface energy plastics, including many grades of polypropylene, polyethylene, and thermoplastic elastomers (TPE`s) without special surface preparation.

Chemical Base Acrylic
Color Black
Container Volume 35 Millilitre
Full Cure Time Temperature Time 8-24 hours @ 23 C (73 F)
Hardness 60 Shore D
Mix Ratio 9.16 : 1
Mix Ratio Volume 0.417361111
Peel Strength At 72 Degrees F (22 Degrees C) 17 Pound Per Inch (Of Width)
Physical Form Paste
Product Form Each
Product Type Structural Adhesive
Shear Strength At 72 Degrees F (22 Degrees C) 2400 Pound-Force Per Square Inch
Shelf Life 6 Month
Shelf Life (not At Room Temperature) 6 months @ 40 F or below
Storage Temperature 40 Degree Fahrenheit
Time To Handling Strength 2 Hour
Work Life 2.5-3 minutes @ 23 C (73 F)
3M™ Scotch-Weld™ Structural Plastic Adhesive DP8010 (Off-White), 35 mL is rated 5.0 out of 5 by 1.
Rated 5 out of 5 by from Porta Bote Owners, This Product is for You If you own a Porta Bote you know nothing will stick to the indestructible material the boat is constructed with. With my used Porta Bote, the transom bladder developed leaks in the corners, then tore at the seams. With 3Ms 8010 structural adhesive, I've repaired the bladder. I intend to order more of the 8010 to treat developing seam leaks and expect it to work wonders. If you are tired of not finding a permanent solution to your Porta Bote issues, try this adhesive. It works on Starboard ®, too. The outlay for the applicator makes the initial cost high, but over the course of a few seasons the overall savings and a "one time fixed and that's it," solution makes the suggested tapes seem silly. If you have a Porta Bote you need this product. 
Date published: 2014-03-08